欢迎访问《金属矿山》杂志官方网站,今天是 分享到:

金属矿山 ›› 2011, Vol. 40 ›› Issue (11): 163-165.

• 综合利用 • 上一篇    下一篇

超声波强化浸出废镀锌板炼钢粉尘试验研究

李岩,徐政,王巍   

  1. 北京有色金属研究总院
  • 出版日期:2011-11-15 发布日期:2011-11-17

Study on Ultrasonic on the Intensification of Leaching on Steelmaking Dust From Waste Galvanized Sheet

Li Yan,Xu Zheng,Wang Wei   

  1. General Research Institute for Nonferrous Metals
  • Online:2011-11-15 Published:2011-11-17

摘要: 对超声波强化浸出含铁酸锌的废镀锌板炼钢粉尘进行了研究,并与常规浸出进行了对比。探讨了初始酸浓度、浸出时间、液固比、超声波强度对浸出率的影响。试验表明,采用超声波强化浸出可使常温弱酸下不溶的铁酸锌浸出。在初始硫酸浓度为200 g/L,浸出时间为120 min,液固比为10的条件下,辅以频率为20 kHz、强度为2 W/cm2的超声波加以强化,此粉尘锌的浸出率可达到90%以上。  

关键词: 超声波, 强化浸出, 炼钢粉尘

Abstract: Stuclied the ultrasonic on the intensification of leaching on steelmaking dust which contains ZnFeO4 ,and contrast this craft with traditional leaching craft. The effect of initial acid concentration,leaching time,solid/liquid ratio and the intensity of ultrasonic to the leaching rate was also discussed. The results show that,with ultrasonic on the intensification of leaching,ZnFeO4 ,which do not be dissolved in weak acid leaching agent in normal temperature,will be leached. With the conditions of initial H2SO4 concentration 200 g/L,leaching time 120 min,S/L ratio 10,and 20 kHz,2 W/cm2 ultrasonic,the leaching rate of zinc will be more than 90%.

Key words: Ultrasonic, Strengthening leaching, Steelmaking dust