欢迎访问《金属矿山》杂志官方网站,今天是 分享到:
×

扫码分享

金属矿山 ›› 2013, Vol. 42 ›› Issue (08): 1-4.

• 采矿工程 •    下一篇

不同应力环境下岩石力学属性及破坏模式研究

罗涛1,2,高永涛1,卢宏建3   

  1. 1.北京科技大学土木与环境工程学院;2.辽宁工程技术大学矿业学院;3.河北联合大学矿业工程学院
  • 出版日期:2013-08-15 发布日期:2013-09-27
  • 基金资助:

    * 教育部重点项目(编号:105016)。

Research on Mechanical Property and Failure Pattern of Rock Samples in Different Stress Conditions

Luo Tao1,2,Gao Yongtao1,Lu Hongjian3   

  1. 1.School of Civil and Environmental Engineering,University of Science and Technology Beijing;2.College of Mining,Liaoning Technical University;3.College of Mining Engineering,Hebei United University
  • Online:2013-08-15 Published:2013-09-27

摘要: 为了研究岩石力学属性及破坏模式的表现规律,在某矿山4个地应力测点处采集岩石样品,结合原岩应力数据,开展了不同应力条件下的室内岩石力学试验。研究表明,单轴受压的软弱岩石通常表现为X型剪切破坏,硬岩则以拉张破坏为主。随着围压增加,岩石均向斜切型剪切破坏模式靠拢,峰值强度和残余强度显著增加,尤其是残余强度增长最快。结合现场应力条件和力学试验得知,五矿1测点处巷道围岩发生岩爆的可能性最大。

关键词: 地应力, 刚性试验, 破坏模式, 岩爆

Abstract: In order to research on the behavior law of mechanical property and failure pattern of rock samples in different stress conditions,rock samples were collected from four in-situ stress measuring points in a certain mine.Afterwards,combining with in-situ stress data,rock mechanics tests in different stress conditions were carried out.The research showed that weak rocks usually shows X-shear failure pattern and hard rock shows extension failure pattern in uniaxial compression test.With the increase of confining pressure,the failure pattern of rock samples changes into oblique-shear failure mode,the peak strength and the residual strength have been increased rapidly,especially,the residual strength grows fastest.Combining on-site stress conditions with mechanical test,it is concluded that the rock-burst in surrounding area of measuring point Wuhkang 1 was most impossible.

Key words: Geostress, Rigid test, Failure pattern, Rock-burst