欢迎访问《金属矿山》杂志官方网站,今天是 分享到:
×

扫码分享

金属矿山 ›› 2026, Vol. 55 ›› Issue (10): 231-238.

• • 上一篇    下一篇

覆岩离层空间体积时空动态演化规律数值模拟研究

江 宁1 ,张阳阳1 ,叶 磊2 ,张伟强3 ,侯英卓4 ,吕 涛1,5 ,巩 超5   

  1. 1.山东科技大学能源与矿业工程学院,山东 青岛 266590;2.山西朔州平鲁区龙矿大恒煤业有限公司,山西 朔州 036000; 3.山东晟源地质勘查有限公司,山东 泰安 271000;4.山东省地矿工程勘察院,山东 济南 250013; 5.山东省地矿工程集团有限公司,山东 济南 250000
  • 出版日期:2026-11-03 发布日期:2026-11-10
  • 作者简介:江 宁(1989—),男,教授,博士。
  • 基金资助:
    国家自然科学基金项目(编号:52574216,52374127);山东省高等学校青创科技支持计划(编号:2023KJ302);山东省自然科学基金重 大基础研究项目(编号:ZR2024ZD22)。

Numerical Simulation Study on Space-Time Dynamic Evolution Law of Overburden Bed Separation Space Volume

JIANG Ning1 ,ZHANG Yangyang1 ,YE Lei2 ,ZHANG Weiqiang3 ,HOU Yingzhuo4 ,LÜ Tao1,5 ,GONG Chao5   

  1. 1.College of Energy and Mining Engineering,Shandong University of Science and Technology,Qingdao 266590,China; 2.Shanxi Shuozhou Pinglu District Longkuang Daheng Coal Industry Co.,Ltd.,Shuozhou 036000,China; 3.Shandong Shengyuan Geological Exploration Co.,Ltd.,Taian 271000,China; 4.Shandong Provincial Geo-mineral Engineering Exploration Institute,Jinan 250013,China; 5.Shandong Geology and Mineral Resources Engineering Group Co.,Ltd.,Jinan 250000,China
  • Online:2026-11-03 Published:2026-11-10

摘要: 覆岩离层注浆技术是解放“三下”压煤的关键技术之一。为实现对单一离层空间体积的动态量化表征, 基于山西某煤矿工作面地质条件,采用3DEC离散元数值模拟,结合岩层位移分离与Surfer软件网格化插值,构建了 覆岩离层空间演化三维模型。系统量化分析了采宽(150、200、250 m)与采高(5.5、6.5、7.5 m)对单一离层空间体积 时空动态演化的影响规律。结果表明:离层空间体积随工作面的推进呈现出清晰的孕育、发展、稳定和闭合四阶段演 化模式;单一覆岩离层空间体积与采宽、采高的大小均呈现正相关,单位开采体积产生的离层量与采宽、采高的大小 同样呈现正相关;采宽与采高的增大主要强化了发展阶段的离层空间体积,并显著提升离层峰值体积。本研究提出 离层空间体积定量计算方法,为覆岩离层注浆减沉参数的动态优化提供了理论依据。

关键词: 覆岩离层注浆 , 数值模拟 , 覆岩离层 , 体积演化 , 岩层控制

Abstract: The grouting technology of overburden separation is one of the key technologies to liberate the " three under " coal.In order to realize the dynamic quantitative characterization of the spatial volume of a single bed separation,based on the geological conditions of a coal mine working face in Shanxi Province,a three-dimensional model of the spatial evolution of over burden bed separation was constructed by using 3DEC discrete element numerical simulation,combined with rock displacement separation and grid interpolation of Surfer software.The influence of mining width (150 m,200 m,250 m) and mining height (5.5 m,6.5 m,7.5 m) on the spatial and temporal dynamic evolution of single bed separation volume was quantitatively ana lyzed.The results show that the space volume of bed separation presents a clear four-stage evolution model of gestation,devel opment,stability and closure with the advancement of working face.There is a positive correlation between the volume of sepa ration space of single overburden and the size of mining width and mining height.The amount of separation produced by unit mining volume is also positively correlated with the size of mining width and mining height.The increase of mining width and mining height mainly strengthens the volume of bed separation space in the development stage and significantly increases the peak volume of bed separation.This study proposes a quantitative calculation method for the volume of bed separation space, which provides a theoretical basis for the dynamic optimization of the subsidence reduction parameters of overburden bed sepa ration grouting.

Key words: overburden rockbedseparationgrouting,numerical simulation,covered rockseparationstrata,evolutionof volume,rockstratacontrol

中图分类号: