欢迎访问《金属矿山》杂志官方网站,今天是 分享到:
×

扫码分享

金属矿山 ›› 2014, Vol. 43 ›› Issue (12): 129-133.

• 稀土工程 • 上一篇    下一篇

用离子型稀土尾矿制备多孔免烧陶粒

徐晶1,严义云1,严群2,焦向科1,3,罗仙平3,4   

  1. 1.江西理工大学资源与环境工程学院,江西 赣州 341000;2.江西理工大学建筑与测绘工程学院,江西 赣州 341000;3.江西省矿冶环境污染控制重点实验室,江西 赣州 341000;4.江西理工大学稀土学院,江西 赣州 341000
  • 出版日期:2014-12-15 发布日期:2015-07-23
  • 基金资助:

    * “十二五”国家科技支撑计划项目(编号:2012BAC11B07),江西省教育厅项目(编号:GJJ14426),江西省科技厅青年科学基金项目(编号:20142BAB216008),“赣鄱英才555工程”领军人才培养计划项目,江西理工大学科研基金重点项目(编号:NSFJ2014-K01)。

Preparation of Porous Non-sintered Ceramsite with Ion-absorbing Type Rare Earth Tailings

Xu Jing1,Yan Yiyun1,Yan Qun2,Jiao Xiangke1,3,Luo Xianping3,4   

  1. 1.School of Resource and Environmental Engineering,Jiangxi University of Science and Technology,Ganzhou 341000,China;2.School of Architectural and Surveying & Mapping Engineering,Jiangxi University of Science and Technology,Ganzhou 341000,China;3.Jiangxi Key Laboratory of Mining & Metallurgy Environmental Pollution Control,Ganzhou 341000,China;4.School of Rare Earth,Jiangxi University of Science and Technology,Ganzhou 341000,China
  • Online:2014-12-15 Published:2015-07-23

摘要: 为实现离子型稀土尾矿的综合利用,减少离子型稀土尾矿对生态环境的影响,以赣南足洞离子型稀土尾矿为主要原料制备多孔免烧陶粒,考察了胶凝材料、激发剂、发泡剂的用量对陶粒性能的影响,并运用扫描电镜(SEM)对所制陶粒的微观形貌进行了表征。试验结果表明:用该离子型稀土尾矿制备多孔免烧陶粒的适宜固体原料配方为稀土尾矿占76%、水泥占10%、生石灰占8%、石膏占4%、铝粉占2%。按此配方制备的陶粒吸水率为30.28%、显气孔率为49.96%、真密度为1.65 g/cm3、抗压强度为3.17 MPa,且含泥量、盐酸可溶率和孔隙率均符合有关标准要求,可用作水处理滤料。SEM分析结果显示,所制陶粒内部孔隙发达,颗粒表面有水化硅酸钙生成。以上研究成果证明,以离子型稀土尾矿为主要原料制备多孔免烧陶粒是可行的。

关键词: 离子型稀土尾矿, 多孔免烧陶粒, 原料配方

Abstract: In order to reduce the impact of rare earth tailings(RET)on the ecological environment and achieve the RET recycling,the ion-absorbing type RET was used as the main raw material for preparing the porous non-sintered ceramsite.The effects of binding material,activating agent and foaming agent amount on ceramsite performance were studied.Scanning electron microscope(SEM)was used to characterize the microstructure of the representative ceramsite.Results showed that the best formula for preparing the ceramsite with the ion type rare earth tailings was 76% RET,10% cement,8% quicklime,2% aluminum powder;Performance indicators of the ceramsite prepared were as follows:water absorption(W)was 30.28%,apparent porosity(P)rate was 49.96%,density(D)was 1.65 g/cm3,and compressive strength was 3.17 MPa;SEM analysis showed that the hole in the ceramsite was well-developed and calcium silicate hydrate(CSH)was generated on the surface of the particle.The study indicates that it is feasible for preparing the porous non-sintered ceramsite with the ion-absorbing type RET as main source material.

Key words: Rare earth tailings, Porous non-sintered ceramsite, Formula for raw material