欢迎访问《金属矿山》杂志官方网站,今天是 分享到:
×

扫码分享

金属矿山 ›› 2015, Vol. 44 ›› Issue (06): 171-174.

• 综合利用 • 上一篇    下一篇

高硫氰化尾渣还原焙烧脱硫—磁选试验

李正要,曹君磊,邓文翔,王维维,乐坤   

  1. 北京科技大学土木与环境工程学院,北京 100083
  • 出版日期:2015-06-15 发布日期:2015-08-05

Study of Reduction Roasting Desulfurization-Magnetic Separation for High Sulfur Cyanide Tailing

Li Zhengyao,Cao Junlei,Deng Wenxiang,Wang Weiwei,Yue Kun   

  1. School of Civil and Environment Engineering,University of Science and Technology Beijing,Beijing 100083,China
  • Online:2015-06-15 Published:2015-08-05

摘要: 江西某冶炼厂氧化焙烧氰化尾渣含铁43.15%,含硫1.97%,属高硫氰化尾渣,采用常规选矿方法、磁化焙烧—磁选工艺难以获得理想的铁回收率指标。为开发利用该尾渣,对其进行了还原焙烧同步脱硫回收铁工艺研究。试验确定的最佳焙烧条件为:烟煤用量20%、脱硫剂BK用量16%、还原焙烧温度1 150 ℃、焙烧时间45 min。最佳焙烧条件获得的焙烧产品经两段阶段磨矿阶段弱磁选试验,获得了产率42.71%、铁品位92.05%、硫含量0.04%、磷含量0.04%、铁回收率91.11%的还原铁产品,为高硫氰化尾渣资源化提供了一种新途径。

关键词: 高硫氰化尾渣, 还原焙烧, 脱硫, 磁选

Abstract: Experimental research on the reduction roasting and synchronous desulfurization for recovering iron from a high sulfur cyanide tailing with iron grade of 43.15% and sulfur content of 1.97% in Jiangxi Province was tested.The results indicated that the optimum parameters were proposed as follows:the mass ratio of the cyanide tailing,the bituminous coal,and desulfurizer BK of 100∶20∶16,the reduction temperature of 1 150 ℃,the roasting time of 45 min.The direct reduction iron with productivity of 42.71%,iron grade of 92.05%,sulfur content of 0.04%,phosphorus content of 0.04%,and iron recovery rate of 91.11% was obtained through the process of two-stage grinding and magnetic separation for the reduction roasting products.It provides a new way for the utilization of the high sulfur cyanide tailing.

Key words: High sulfur cyanide tailing, Reduction roasting, Desulfurization, Magnetic separation