欢迎访问《金属矿山》杂志官方网站,今天是 分享到:

金属矿山 ›› 2008, Vol. 38 ›› Issue (01): 93-96+154.

• 机电与自动化 • 上一篇    下一篇

喂料方式对涡流空气分级机分级性能的影响

冯永国,刘家祥,刘圣照   

  1. 北京化工大学
  • 出版日期:2008-01-15 发布日期:2011-07-23
  • 基金资助:

    国家自然科学基金项目(编号:50474035)。

Effect of Feeding Mode on Classification Performance of Vortex Air Classifier

Feng Yongguo,Liu Jiaxiang,Liu Shengzhao   

  1. Beijing University of Chemical Engineering
  • Online:2008-01-15 Published:2011-07-23

摘要: 采用水泥生料和重质碳酸钙试验研究了涡流空气分级机,经机械打散装置预打散物料与不经机械打散装置直接进行分级的两种喂料方式对分级机分级性能的影响。结果表明,在高风速范围内增加打散装置对分级粒径的影响不大,但可以明显提高分级精度;增加打散装置后水泥生料的分级精度明显高于重质碳酸钙的分级精度。由于粒径和结构的差异,水泥生料易团聚,表明此打散装置更适合用于易团聚物料的分级。

关键词: 涡流空气分级机, 喂料方式, 分级

Abstract: The effect of two feeding modes (with and without mechanical pre-dispersion of the feed) on the performance of vortex air classifier was tested using cement raw material and heavy calcium carbonate as feed. The results show that the mechanical dispersion device at high wind velocity has little effect on the classification particle size but can evidently improve the classification accuracy. When the dispersioning device is used, the classification accuracy for cement raw material is evidently higher than that of heavy calcium carbonate. Cement raw material is apt to agglomerate due to the difference in its particle size and structure. It is indicated that this dispersioning device is more suitable for the classification of materials that are easy to agglomerate.

Key words: Vortex air classifier, Feeding mode, Classification